Friday, September17, 2021
Privacy Policy
L-36.com

'3 Strand Eye Splice'


Note:

This is the new page for displaying documents. It allows documents to display on devices without pdf viewers specifically mobile devices, a new Google requirement. Note also that some documents have blank pages. Just click on "Next Page" if that happens.
Previous Page    Next Page
Go to page number
Note: Page number may not agree with index page numbers


Previous Page    Next Page
Go to page number
Note: Page number may not agree with index page numbers

PDF to Text.
e y e s pl i c e 3strand Class I Class I ropes are made from any or all of the following fibers olefin polyester or nylon Additional rope needed for splice The eye splice is used to place a permanent loop in the end of a rope generally for length of 16 crowns plus length of eye with thimble length of 16 crowns plus 12 cerc in feet attachment purposes to a fixed point An eye is also used to form the rope around a thimble which is used to protect the rope especially when it is to be attached to a shackle chain or wire rope Although the 3strand splice is the most common splice and simple to perform Apply tape to mark eye technique is important to preserve splice strength Take care that the tucks lie neatly Crown 1 Pic rope strength can be lost if the strands are twisted incorrectly Getting Started From one end of the rope count back 16 crowns Tape this section Standing part of line Unlay the rope up to the tape then tape the end of each strand Form the eye and tape the standing part of the rope To avoid a twist in the eye of the finished splice ns untwist the rope onehalf turn between the pieces of tape C row 16 1 tucking first strand step With a fid or your finger raise a strand just below the tape on the standing part of the rope and insert the middle working strand under it and pull the strand through Mark the first tucked strand with a single hash mark numbering the working strands will help you keep track of the tucking process 2step tucking second strand Pass the next working strand over the strand you just tucked under then tuck under the strand just below it Mark this strand with a double hash mark 3 t u c k i n g T H IRD s t r a n dstep Turn the entire piece over There is one working strand left to tuck and there is one strand left in the standing part of the rope that does not have a working strand under it Make this tuck continuing to work counter to the lay or twist or the rope Mark this strand with a triple hash mark The first round of tucks is complete Tighten if necessary by pulling on the strand ends When you tuck take care to use all three strands in each round and that you tuck under a strand in the standing part of the rope and not under one of your working strands 4 ep FINIS H ING T H E S P L ICE st To finish the splice perform four more complete tucks Tighten tucks if necessary Both the front and the back of the splice should resemble the illustrations shown Front of finished splice Back of finished splice 2090 Thornton Street T 3603844669 Ferndale WA USA 98248 F 3603840572


Please read website Cookie, Privacy, and Disclamers by clicking HERE.