L-36.com

Tuck Bury Splice Class 2,12 Strand Ropes


Note: This is the new High Definition version of the Manual viewer with 4x the number of pixels per page.
Some manual pages may be blank. There will be an End of File notice after the last page.

Previous Page    Next Page
Go to page number
Note: Page number may not agree with index page numbers

PDF to Text.
Tuck bury splice 12strand HMPE ONLY The Tuck Bury splice is designed as a short splice for HMPE Dyneema fiber 12 strand ropes only Additional rope needed for splice 134 fid lengths plus length of eye with thimble 134 fid lengths plus 12 1 circ in feet measuring and marking step Tape end to be spliced Then measure 112 fid lengths 112 Fids from the bitter end and mark This is Mark 1 Put tight Mark 1 tape wrap at Mark 1 Mark 3 1A From Mark 1 form a loop the size of the Mark 2 Form size of eye desired and mark This is Mark 2 eye desired 134 Fids 1B From Mark 2 measure down the rope 134 fids and mark This is Mark 3 2 Mark Mark11 ta p e r i n g t h e ta i l BitterEnd Bitter Endstep At Mark 1 pull out half the strands three S and three Z by rotating around the rope pulling out strands in the pattern shown s Z Strand counter clockwise twist z s S Strands clockwise twist This should leave six strands still braided down the middle z s Tightly tape the ends of the six individual strands z and the end of the remaining braided portion 2A On one side you should have two S and one Z and on the other side two Z and one S 3 b u r y i n g t h e ta i l s zstep 3A Pass the three strands closest to Mark 2 through s the rope at Mark 2 Do not pull strands all the way through at this stage 3B With all six strands that are still braided start to bury them down the center of the rope entering at Mark 2 and exiting at Mark 3 Tail should enter standing part at the same point where the three strands pass through the rope Pull the tail out until Marks 1 2 meet Taper end of tail by s cutting across at 46 angle s z z s s z s z z s z Page 1 of 2 2090 Thornton Street T 3603844669 Ferndale WA USA 98248 F 3603840572 Tuck bury splice 12strand HMPE ONLY s 3c Smooth bunched line away from eyeThe braided portion of the tail should disappear into the standing part of line s z 3d When the braided section is buried make sure that the three strands that have been passed through the rope z s z are all the way throughwith no slack in the strands s z s z s z 4 tucking the strands epst Start the tuck splice the same way as a standard tuck splice One complete tuck consists of passing a strand over one strand and under two strands 4A Do three complete tucks for all six strands Each strand is always tucked under the same line of the braid so that the tucks progress straight down the body of the rope z s 4B After completing the first three tucks remove 12 of the volume of the twisted yarns from each of the six strands s near the taped ends and complete three more tucks with the reduced volume strands s z z s s z z s z 5step Finishing the splice After completing the second set of three tucks cut off the excess material and tape the ends Leave enough of an end protruding so that the end does not slip back into the rope when the rope is loaded Page 2 of 2 2090 Thornton Street T 3603844669 Ferndale WA USA 98248 F 3603840572


NOTICE: Some pages have affiliate links to Amazon. As an Amazon Associate, I earn from qualifying purchases. Please read website Cookie, Privacy, and Disclamers by clicking HERE. To contact me click HERE. For my YouTube page click HERE