Wednesday, November13, 2019

Rutland Hub Bearing Replacement


This is the new page for displaying documents. It allows documents to display on devices without pdf viewers specifically mobile devices, a new Google requirement. Note also that some documents have blank pages. Just click on "Next Page" if that happens.
Previous Page    Next Page Go to page number Note: Page number may not agree with index page numbers

End of File

Previous Page    Next Page
Go to page number
Note: Page number may not agree with index page numbers

PDF to Text.

(For models: 910 Standard, FM910, FM910-3, & 913) Kit contents:You require: Two Type 6202 Bearings c/w rubber seals Loctite 648. Part No. 921-001.

To replace worn hub bearings:1. Remove the blades. Two screws per blade on Mark I machines and four screws per blade on Mark II machines. Remove the side cover plate (910 series) or slide nacelle back (913) and remove wires from the choke and from the rectifier. Machines fitted with twin rectifiers remove wires from the rectifiers. Make careful note of which wire goes where for re-assembly. Slacken the two shaft locknuts and screws and slide the hub out of the windshaft support casting. Remove the six screws joining the hub halves together. Insert two of these screws in the back of the hub (910 series), or three screws in the front hub (913). Gradually turn the screws jacking the two hub halves apart. Once the hub is apart the stator can be removed. The bearings are pressed onto the shaft and into the hub by Loctite Grade 648 and can be removed with a suitable bearing puller. Before replacing the bearings remove all the loctite deposits from the shaft and bearings. This is most important to allow the halves to be joined properly. Use Loctite 648 to bond the new bearings onto the shaft and into the hub halves. When re-assembling it is essential the indents on the mating face of each hub half line up with each other. When the hub is apart care should be taken to ensure that no steel or magnetic particles are picked up by the magnet. It is also essential to make sure that the magnets are clean before re-assembly. Once assembled allow at least one hour for the Loctite to harden before turning the shaft. Please allow 24 hours before re-commissioning the wind generator.






7. 8.


When offering hubs towards each other they will be attracted together by a large magnetic force capable of severely damaging your fingers !!

Document No.TD-101 Issue D


Ad by Google

The information on this web site has not been checked for accuracy. It is for entertainment purposes only and should be independently verified before using for any other reason. There are five sources. 1) Documents and manuals from a variety of sources. These have not been checked for accuracy and in many cases have not even been read by anyone associated with I have no idea of they are useful or accurate, I leave that to the reader. 2) Articles others have written and submitted. If you have questions on these, please contact the author. 3) Articles that represent my personal opinions. These are intended to promote thought and for entertainment. These are not intended to be fact, they are my opinions. 4) Small programs that generate result presented on a web page. Like any computer program, these may and in some cases do have errors. Almost all of these also make simplifying assumptions so they are not totally accurate even if there are no errors. Please verify all results. 5) Weather information is from numerious of sources and is presented automatically. It is not checked for accuracy either by anyone at or by the source which is typically the US Government. See the NOAA web site for their disclaimer. Finally, tide and current data on this site is from 2007 and 2008 data bases, which may contain even older data. Changes in harbors due to building or dredging change tides and currents and for that reason many of the locations presented are no longer supported by newer data bases. For example, there is very little tidal current data in newer data bases so current data is likely wrong to some extent. This data is NOT FOR NAVIGATION. See the XTide disclaimer for details. In addition, tide and current are influenced by storms, river flow, and other factors beyond the ability of any predictive program.